Interfire Audio A1000.2 Bedienungsanleitung

2 CHANNEL / 4 CHANNEL / 5 CHANNEL AUTOMOTIVE AMPLIFIERINSTRUCTION MANUALA300.2 / A500.2 / A700.2A1000.2 / A1100.2 / A2200.2A500.4 / A700.4

CH2POWERB+GND REMFUSESPEAKER(+) (+) (+) (+)CH4CH3ONPROTECTCH1BRIDGED BRIDGED2 SPEAKER BRIDGED2 SPEAKER + 1 SUBWOOFER4 SPEAKER STEREO6 SPEAKER HEX MODE

4-8 Ohms1 CH 2 CHBRIDGED BRIDGEDPOWERB+GND REMFUSESPEAKER(+) CH4 (+) CH5(+) CH3ONPROTECT(+)CH1(+)CH2BRIDGED BRIDGEDPOWERB+GND REMFUSESPEAKER(+) CH4 (+

111.Set to the "H.P.F" position when the amplifier is used to drive a tweeter/midrange system. The frequencies below the crossover point w

12

13

14 This section provides you with a catalog of amplifier symptoms and their probable causes and solutions. Before you consult this listing, make sure

AMPLIFIER4 OHMS @ 0.05% THD4 OHMS Bridged 0.5% THDLOW PASS FILTERHIGH PASS FILTERMAXIMUM OUTPUT POWERFUSE RATINGFREQUENCY RESPONSE (-1dB)SIGNAL TO NOI

AMPLIFIER4 OHMS @ 0.05% THD4 OHMS Bridged 0.5% THDLOW PASS FILTERHIGH PASS FILTERMAXIMUM OUTPUT POWERFUSE RATINGFREQUENCY RESPONSE (-1dB)SIGNAL TO NOI

1free installation.• Four Class ''AB'' High-Current Dual Discrete Drive Stages.• Class ''AB'' Technology MOSFE

• NEVER operate the amplifier without the proper power and ground wire, 10 gauge minimum.• NEVER operate the amplifier without proper fusing. Fuse hol

1. After reading precaution, decide where you are going to install the unit. Also, see Fig.1.2. Once the location has been determined, place the ampli

It is important to have good quality power and ground connections. Remember, to complete an electrical circuit, the ground connection is just as impor

5FIG.2+12V REM GND AUTO - ANTENNA LEADCH1 CH2CAR STEREO HEAD UNITLINE INPUTGAIN BASSL.P.FL.P.FH.P.FH.P.F6V 0.2V 0dB12dB50Hz250HzFLAT80Hz1.2KHz

6CH3 CH4CH2CH1+12V REM GND AUTO - ANTENNA LEADCAR STEREO HEAD UNITFIG.2LINE INPUT LINE INPUTGAIN GAINBASS BASSCROSSOVER CROSSOVER6V 0.2V 0dB12d

7CH3 CH4CH2CH1 CH5 CH6+12V REM GND AUTO - ANTENNA LEADCAR STEREO HEAD UNITFIG.26V 0.2VFLATL.P.F250Hz50Hz 1.2kHz80Hz 1.2kHz80Hz 250Hz50HzH.P.FGA

POWERB+GND REMFUSESPEAKERCH1(+) (+)ONPROTECTBRIDGEDCH2POWERB+GND REMFUSESPEAKERCH1(+) (+)ONPROTECTBRIDGEDCH2POWERB+GND REMFUSESPEAKERCH1(+) (+)ONPROTE